You choseAdd or modify filters Remove filters
Can Stack Motors
Often referred to as a “Can Stack","tin can”, or“ permanent magnet” motors, the can stack motor is a low cost and low resolution stepper motor with typical step angles of 7.5 to 18° (48 – 20steps/revolution). Can Stack motion technology focusses on simplicity and uses the simplest of techniques and designs to create an effective motion solution. Can stack motors are usually 2 phase in construction. They consist of two stator cups with claw tooth poles formed around a winding creating each half of the motor. The rotor has the same number of pole pairs as the stator, while the poles on each stator cup are constructed to be a half a pole pitch apart. With two coils, this means there can be 4 discrete positions per pole pitch. A 2-phase motor, for example, with 12-pole pairs in each stator / coil sector will therefore have 48 steps per revolution or 7.5 degrees per step. From 3.9 mNm up to 300 mNm in a size from diam. 15 mm up to 60 mm, our range of permanent stepper motors is the simplest motion solution for a wide range of applications that require high continuous motor torque but don't require the absolute positioning of a servo system.
|Model||Diameter (mm)||Operating Voltage (VDC) (V)||Dielectric Withstanding Voltage (VAC)||Rated Current per Phase (A)||Holding Torque, Min (mNm)|
Stepper motors 26M048B1B
|26||5||650 for 2 seconds||0.25||10.6||VIEW|
|26||12||650 for 2 seconds||0.11||10.6||VIEW|