Can Stack Motors

Often referred to as a “Can Stack","tin can”, or“ permanent magnet” motors, the can stack motor is a low cost and low resolution stepper motor with typical step angles of 7.5 to 18° (48 – 20steps/revolution). Can Stack motion technology focusses on simplicity and uses the simplest of techniques and designs to create an effective motion solution. Can stack motors are usually 2 phase in construction. They consist of two stator cups with claw tooth poles formed around a winding creating each half of the motor. The rotor has the same number of pole pairs as the stator, while the poles on each stator cup are constructed to be a half a pole pitch apart. With two coils, this means there can be 4 discrete positions per pole pitch. A 2-phase motor, for example, with 12-pole pairs in each stator / coil sector will therefore have 48 steps per revolution or 7.5 degrees per step. From 3.9 mNm up to 300 mNm in a size from diam. 15 mm up to 60 mm, our range of permanent stepper motors is the simplest motion solution for a wide range of applications that require high continuous motor torque but don't require the absolute positioning of a servo system.
Model Diameter (mm) Holding Torque, Min (mNm) Detent Torque, Max (mNm) Step Angle (degree) Steps per Revolution Price
44M100D1B
Portescap
44 46,6 8,47 3,6 100 VIEW
44M100D2B
Portescap
44 46,6 8,47 3,6 100 VIEW